- Pickering Interfaces Inc.
product
PXI 8 Slot BRIC 352x4 2-pole (8 sub-cards)
40-562A-122-352X4
This version of our BRIC is part of a range of high-density PXI matrix modules. These modules are available in 2, 4 or 8-slot PXI sizes to suit all high performance matrix requirements and are constructed using instrumentation quality reed relays. With this high level of switching density, these PXI matrix modules allow a complete Functional ATE system to be housed in a single 3U PXI chassis. These BRIC matrix modules allow the use of lower cost 8 or 14-slot PXI chassis.
-
product
Probe System
Acculogic Sprint 4510
The Sprint 4510 family of flying probers are well known for their speed, reliability, ease of use and large world-wide installed base.Flying probe testers have few restrictions on access, require no test fixtures, and can test boards with virtually unlimited number of nets, allowing test developers to turn a program around in a short time.
-
product
Aircraft Propulsion Systems
Lycoming® Engines
Lycoming engines are built in Williamsport, Pennsylvania. Lycoming Engines' Williamsport facility is focused primarily on the engineering, manufacture, assembly, test, and support of piston aircraft engines for manned and unmanned aircraft.
-
product
Medical System
Sentinel III
Chroma Systems Solutions, Inc.
The Sentinel III System provides complete Electrical Safety Testing to IEC60601-1 and IEC 60601-2-49 (Multifunctional Patient Monitoring Equipment) in a fully automated fashion. The Sentinel III saves time by scanning patient connections for leakage current without powering down the device.
-
product
Mezzanine System
3564
The 3564 is a four channel comparator board with a common mode range of -150V to 150V on the two differential inputs and a DAC per channel to set trigger levels. The high common mode range and DC coupling provides a robust solution to level detection and triggering.
-
product
Mezzanine System
5041
ECM P/N 5041 provides eight channels of RS485 / RS422 I/O with fixed 120 ohm termination for each channel. Speeds are up to 30M bits per second. All channels power up as inputs. Also transceiver inputs are always enabled for loop back diagnostic use when the outputs are enabled. Software can enable outputs on a channel by channel basis.
-
product
Mezzanine System
5093
ECM P/N 5093 provides 2 independent full bridge circuits. The two full bridge circuits can be used together to drive one small two phase stepper motor. Each full bridge circuit can drive one small dc motor or other bipolar load. Note all inductive loads should employ transient protection.
-
product
Blackbody System
IR-2103/301
Infrared Systems Development Corp.
Infrared Systems Development introduces a NEW Low-Cost Thermo-Electrically cooled / Heated blackbody source. The 0.375" Thick solid Copper Emitter plate provides superior uniformity and energy emission. Our Proprietary High Emissivity Black Coating provides >0.95 uniform Emissivity from 0.8 to 30 um.
-
product
Design and Development: Complete Systems and System Components
Custom Systems Integration Inc.
CSI''s design and development (D&D) organization has the resources, skill and experience to design a complete turnkey system, a system component or collaborate with customer''s internal staff on any part of a system.
-
product
Wireless Data Logging System
MicroLogPLUS
A wireless data logging system for remote monitoring of up to 200 data loggers via the cradle technology and transmitting all real-time measurements to the PC. Handles data from up to 200 MicroLogs at up to a distance of 300m (120m US Version). Two open collector output for controlling other devices set at low and high alarm levels
-
product
Multi-Mission System
Improved Shadow® Tactical Unmanned Aircraft Systems
With more than 30 years of unmanned aircraft systems (UAS) experience, Textron Systems' Shadow® is the most reliable and capable tactical UAS to help you accomplish your missions. The battle-proven system has surpassed 1.25M hours in flight, supporting global military operations for countless U.S. troops and their allies. Our multi-mission systems are paired with Textron Systems' interoperable Universal Ground Control Station (UGCS) and remote products for collaboration across the battle space.
-
product
Semi-automatic Measuring And Alignment System
McBain Z-NIR Near Infrared Inspection Microscope
The McBain Z-NIR Near Infrared Inspection System is best-in-class for wafer-to-wafer and die-to-die alignment measurement and verification. This unique tool has been sold into many industries with various applications including sub-surface wafer and die inspection for cracks and bond integrity, MEMS, wafer bonding, 3-D chip stacking, failure analysis, process development, tool verification, part characterization, environmental testing and more.
-
product
Mezzanine System
5085
ECM P/N 5085 provides two channels of 24 bit A/D conversion suitable for high resolution low speed applications, which include bridge circuits, thermocouples, RTD and voltage measurements. For bridge applications each channel provides a fused +5 Volt or a current source drive.
-
product
System Architectures
Tracewell has extensive experience designing and manufacturing systems based on standard architectures including VPX, VXS, VME, VME64x, VXI, ATCA, MicroTCA, and CPCI. The Tracewell System Architecture (SA) products, based on standard, commercial technologies can be used in a wide variety of commercial and military applications including: battlefield command & control systems, ground and flight sensor control systems, vehicle navigation controls, and medical imaging devices.
-
product
Data Acquisition System
DataNet
High-end 16-bit intelligent data acquisition system, utilizing ZigBee wireless telemetry protocol, with 4 inputs for direct measurement.
-
product
Analog Ultrasonic Detection System
ULTRAPROBE 2000
Designed for ease of use, it often takes no more than 15 minutes to become competent in testing with the ULTRAPROBE 2000 Kit Complete. Fast accurate diagnosis through the ULTRAPROBE 2000 System will dramatically reduce unplanned down time and shorten planned outage time.
-
product
Mezzanine System Carrier
MMS8010 / MMS8011
The Abaco ECM 3U VPX carrier supports up to six Abaco Systems Electrical Conversion Modules (ECMs) in a VITA 46 VPX form factor. Each ECM site connects 32 single-ended 3.3 V signals to the FPGA. The specific ECM board installed on a site converts the FPGA signals to 16 I/O signals, for a total of 96 I/O signals across the six ECM sites.
-
product
SABRE Rugged Systems
The SABRE family from Diamond Systems offers an attractive combination of features, ruggedness, and economy. These systems feature full IP67 rating and MIL-STD-810G compatibility and are ideal for vehicle and other harsh environment applications. Standard configurations offer quick turn solutions based on proven designs, while the system architecture supports quick and low-cost customization with the addition of PC/104 and PCIe MiniCard I/O modules.
-
product
Circuit Breaker Test System
TDR900
It operates and records a circuit breaker’s contact timing, motion, velocity, main contact engagement & synchronization, trip and close coil initiation and currents.
-
product
Blackbody System
IR-2106/301
Infrared Systems Development Corp.
Infrared Systems Development introduces a NEW Low-Cost 6” x 6” Thermo-Electrically cooled / Heated blackbody source with a temperature range of 5ºC to 150ºC. The solid Copper Emitter plate provides superior uniformity and energy emission. Our Proprietary High Emissivity Black Coating provides >0.95 uniform Emissivity from 0.8 to 30 um.
-
product
Digital Map Systems
Elbit Systems of America’s Global Digital Map Unit is built on a proven design that accommodates multiple data formats and provides unmatched situational awareness to aircrews. The GDMU displays detailed map, flight plan, and threat information to aircrews. Each system performs interactive functions with the mission computers and generates digital video map data for head down displays.
-
product
Modular Test System
DMT
The DMT Tester is a modular test system that allows rapid measurement of electrical and non-electrical parameters of functional units. The system also allows basic ICT measurement with optional accessories. It is conceived as modular, with the possibility of integrating a wide range of own and external instruments. The DMT tester is controlled by its own SCADUS software.
-
product
Medical System
Sentinel I
Chroma Systems Solutions, Inc.
The Sentinel I System provides fully automated Electrical Safety Testing to IEC/EN/UL/CSA 60601-1. This system is ideal for testing medical products with one or no patient connections or low volume production where operators can manually change leads between different patient connections. This is a 5 in one Hipot test system that can test Hipot, Ground Bond, Insulation Resistance, Patient Leakage, Earth Line Leakage, Enclosure Leakage and Patient Auxiliary Leakage.
-
product
Observation Systems
The AN/PAS-22 Long Range Thermal Imager (LRTI) is a high-performance, handheld, thermal sight with optical zoom and image stabilization that uses a cooled and highly-sensitive focal plane array. The AN/PAS-22 LRTI offers maximum range and performance in a durable, handheld 6.8 pound package.
-
product
Portable Data Acquisition & Analysis System
LapCAT III
# 4, 8, or 16 channels# 1 MHz aggregate 12 bit sampling. Resolution is 0.024% of full scale# 13 recording durations, user selected: 132 msec to 1320 sec# Digital Triggering from any channel, with +/- slope or window# 6 full scale gain ranges, user selected: 0.4, 1, 2, 4, 10, and 20 volts full scale - with a 10mV/g accelerometer these equal 40g, 100g, 200g, 400g 1000g and 2000g full scale - higher or lower ranges by different sensor selection
-
product
Data Collection and Analysis System
3002
The Model 3002 SER System is a state of the art data collection and analysis system. It is suitable for application in an electrical utility substation or plant environment to produce Sequence of Event (SER) data in conformance with PRC-002-1 and PRC-018-1.
-
product
Computing VITA System
CRS 48.5
The CRS 48.5 is a complete, integrated, pre-tested, ready-to-run HPEC rugged subsystem enabling faster development/deployment at lower cost and risk using the most advanced VITA 48.5 compliant air-flowthrough cooling to allow the integration of up to eight quad core Intel® Core™ i7 processing nodes.
-
product
Advanced Metrology System
NGS 3500L
This top performance system is designed for applications where high-speed defect detection and precision measurements on wafers and other parts are required. It is well suited for use as a dedicated production tool or as a versatile processdevelopment system. It features a powerful set of automated as well as semi-automatic optical/ video tools optimized for high accuracy, production throughput, and ease of use.
-
product
Multi-Axis Hot Deformation System
MAXStrain
The system restrains specimens lengthwise while allowing unlimited deformation in the other two dimensions. As a result, very high strain levels can be introduced into specimens to produce a sample of ultrafine-grain or nanoscale material that is large enough for subsequent properties testing.